Mafra Maniac Line ™ Foam Gun Prewash is a powerful and safe dry and compact foam gun for use in the pre-wash phase. It respects the previously applied protective agents, even nanotechnology-based protective or coating.
This product, when used in combination with a pressure washer, eliminates 90% of dirt, thus preventing swirls or micro-scratches in the subsequent washing phases.
- FOAM: Foam Gun Prewash is a powerful foaming agent for car detailing to be used in the pre-wash phase;
- EFFECTIVE CLEANING: thanks to its great cleaning capacities it is able to eliminate smog, road dirt, midges, and organic residues of plants and birds;
- MULTIFUNCTIONAL: the product can be used with a pump sprayer that launches foam. If used with a pressure washer, it eliminates 90% of dirt and avoids micro-scratches during the washing phase;
- PERFUMED: once used, the product releases a pleasantly scented fragrance;
- DILUTION: With Foam Gun, dilute 1: 5 in winter and dilute 1:10 in summer. With a low-pressure manual pump, dilute 1:50 in winter and dilute 1: 100 in summer.
How To Use:
it is recommended for use through a foam gun but can be used as an excellent pre-wash with a low-pressure manual pump:
- With Foam Gun:
- In winter dilute 1: 5 (1 part of product and 5 of water), to make a final dilution of 1:50 at the outlet;
- In summer dilute 1:10 (1 part of product and 10 of water), to make a final dilution of approximately 1: 110 at the outlet;
- Apply a thick layer of foam to the vehicle;
- Leave the product to act on the surface and wait for the foam to start falling (this may take up to 5 minutes);
- Rinse the vehicle from top to bottom
- With low-pressure manual pump:
- In winter, dilute 2 caps in 1 litre of water 1:50 (1 part of product and 50 of water)
- In summer, dilute 1 capful in a litre of water 1: 100 (1 part of product and 100 of water)
- Dispense the product on the vehicle
- Leave the product to act on the surface for one minute without allowing the product to dry on the bodywork;
- Rinse the vehicle from top to bottom
Recommendations:
Make sure the vehicle surface is cold and the car is in the shade avoiding direct sun.
Before using the product, in summer, rinse the vehicle to cool the surface or remove the first part of the dirt.
The product must be dispensed from the bottom upwards. During warm seasons, work on one panel at a time to prevent the product from drying on the surface.
It is possible to dispense the product directly on the bodywork without wetting it first, even in the presence of deeply anchored dirt such as midges and the lowest parts of the car which are always the dirtiest.
In the presence of mud, remove it with a jet of water before dispensing the product.
